WE MOVED April 2019   NEW ADDRESS: 1265 E Knittles Kove, Lehi, UT 84043
ConfiDent Biomimetic Dental Lab
  • Confident Dental Lab Home
  • About us:
    • Before and After Photos
    • Onlay Pictures
  • Contact us!
  • Prescription Slips for Dentists
  • Products used:
    • IPS- Emax
    • Clearafil Majesty
    • Feldspathic
  • Weekly Blog

New and improved ways to take a good impression the first time: Chapter 1

2/26/2014

0 Comments

 
              In the dental profession, time in the chair is money, the more people you can get in the chair the better. EXCEPT when they are repeat visits because your lab didn't get their work right. Take all your frustrations and wasted time and money and get ready for a change. I will walk you through, step by step, on how to take an impression that both you and your lab technician will have no issues with. Which means, more time open in that chair! Better get your receptionist ready and warmed up because you are going to have more appointment time available.

Ok, so first off, you know that you are going to need some alginate, some impression trays, gloves, etc.
Did you know that by fluffing or aerating the alginate powder will help you get a more accurate water/powder ratio. Kind of like sifting flours for your favorite chocolate chip cookies. Then if you will add the powder after you have put the water in the bowl, it makes it easier to mix, also like when you are making cookies. Don't forget to tap the scoop with powder and level off the top. This will cause too much powder into the mixture and will make your alginate too thick. Two scoops is generally the norm for a full arch impression, but be sure to always read the manufactures guidelines with each different kind of alginate before you begin.
Use cooler water to make the allow more working time. Hot water tends to set it up a little faster.
When mixing, I bet we all wish we could be using grandma's good old Kitchen Aid mixer. Go ahead and mix powder and water together and be sure to press the mixture against the side of the bowl as you rotate it in order to get all the extra air bubbles pressed out. Once again, after checking the materials guidelines; should be around one minute of mixing, make sure that your alginate mix is a soft creamy fusion that is smooth but also does not fall off of your spatula.
Now the race to get your "cookies" into the oven begins. You need to scoop the alginate from all sides of the bowl, but at the same time, try not to let any air bubbles back in. Then spread evenly in the tray. Set time for most manufacturers is three minutes from the start of mixing. Fast-set is two
minutes.
Now time to open the oven and start the baking!


 

0 Comments



Leave a Reply.

    Author

    Lana is our local author.




    Archives

    April 2019
    July 2014
    June 2014
    May 2014
    March 2014
    February 2014

    Categories

    All

    RSS Feed

More information links for Biomimetic Dentistry:
The Alleman Center
Academy of Biomimetic Dentistry
Directory of Biological Dentists
Avoid Root Canals





Contact
About




Proudly powered by Weebly